Repair kit for depress mattresses

Ready-to-use repair kit for vacuum mattresses DEPRESS.

The kit makes it possible to repair the holes and small tears on the polyurethane surface of the DEPRESS mattresses.

The kit includes:
- 1 PATCH SELF ADHESIVE 15x8cm can be cut
- 2 SELF ADHESIVE PATCH 3,5x3,5cm
- 2 SELF ADHESIVE PATCH 2,2x2,2cm
- 5 ALCOHOL WIPES

INSTRUCTION FOR USE :
For holes or tears of polyurethane vacuum mattresses.
1. For best results, apply on a clean and dry surface. The temperature of the polyurethane material to be repaired shall not be less than 10 ° C.
2. CLEAN the surface to be repaired with the supplied alcohol wipes, or a 50/50 mixture of alcohol (isopropyl) and water.
3. Before starting, make sure the surface is dry.
4. CUTTING: Cut the sticker with scissors so that it protrudes approximately 2.5 cm from the edges of the hole or tear. If several stickers are used, they must overlap approximately 2.5 cm. Scissor the 4 corners of the sticker.
5. PAPER REMOVAL: Gently remove 1 cm of paper while pulling on the edges of the sticker. This will facilitate subsequent separation, Especially when the stickers are cut into small sizes.
6. GLUE: Position the sticker so that it can cover beyond the edges of the hole (or tear) about 2.5 cm. Slowly remove the paper from the sticker while gently applying it to the material. Pay attention to air bubbles. Finally, rub all the edges and the entire sticker vigorously.
The repair is over.